Loading... Please wait...

Mach Speed Training Guide

Mach Speed All Purpose Cleaner/Degreaser

 Download Guide

SAFETY GUIDELINES:

1. Wear rubber gloves. (Suggestion Only)

2. Wear safety glasses. (Suggestion Only)

3. No need for special ventilation. Turn on vent fans or open nearby window if necessary. (Suggestion Only)

Note: Mach Speed is a biodegradable, non-acid, high alkaline cleaner that will not harm plants when used outside on walls or driveways.

SURFACES NOT TO BE USED ON:

1. Glass - Do not let Mach Speed sit on for more than 1 minute without wiping off.

2. Mirrors – Wipe off immediately.

3. Aluminum – Do not let Mach Speed sit on aluminum for more than 3 minutes without wiping off. It can be used on aluminum it just needs to be wiped off within specified time period.

PROHIBITED SURFACE PRECAUTIONS AND PROCEDURES:

1. If overspray touches prohibited surfaces simply wipe off with a towel within allotted time periods above.

ACCEPTABLE SURFACES TO BE USED ON:

1. Any surface except for glass and mirrors.

HOW TO USE:

1. As an all purpose cleaner (5:1 to 10:1 dilution with water) – Spray on soap scum, grime, grease, scruff marks on walls, bugs on cars, and wipe clean. For tougher spots let product sit for 30 seconds up to 3 minutes then wipe clean. Always let the product work for you so you don’t have to work as hard. Makes marble and granite countertops shine. A brush can be used for tough soap scum in grout lines of showers and hard to reach areas.

2. As a floor degreaser (10:1 dilution with water) – ½ quart bottle can be mixed with 2 ½ gallons of water to degrease the toughest grease on floors.

3. As a daily floor cleaner (1-2 oz per gallon of water) – Mop tile, marble, granite then let dry.

4. As a driveway cleaner for oil spots etc. (1:1 dilution with water) – Fill a pump sprayer with Mach Speed diluted 1:1 and spray 25 ft. x 25 ft. sections of driveway at a time or directly on problem areas. Scrub with a deck brush and hose or pressure wash off. The product can also be used in a pressure wash tank at 50:1 dilution.

5. As a stain remover for carpets and fabrics (5:1 to 10:1 dilution with water) – Spray Mach Speed on the stain soaking it, let sit 3-5 minutes, then extract with an extraction machine using water only in the tank, or fold a clean towel and blot up cleaner repeating soaking and blotting until stain is gone.

Note: It is important to neutralize the spot where the Mach Speed was used afterward with water because Mach Speed has a high alkalinity. If the spot is not neutralized dirt will be attracted to the cleaned area after it dries. Soak up water or extract after neutralizing and let dry.

Note: Mach Speed will not take the oxygen out of carpet fibers or fabrics, meaning that it will not preset stains.

6. As a carpet cleaner (10:1 dilution with water) – Spray Mach Speed on carpet with a pump sprayer dampening it and let sit 1-3 minutes. Use an extraction machine with only water in the tank to neutralize and extract the product.

Note: Mach Speed will not take the oxygen out of carpet fibers or fabrics, meaning that it will not preset stains.

7. To remove hard water mineral deposits (full strength to 5:1 with water) – Spray Mach Speed on water spots and let sit 30 seconds to 3 minutes then brush and wipe clean with a towel.